LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Engine System-General Information - F250-F550 Super Duty (Gasoline)) >> Diagnosis And Testing >> Engine >> Intake Manifold Vacuum Test >> Oil Pressure Test

Oil Pressure Test

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and remove the oil pressure sensor from the engine.
  2. Connect the Oil Pressure Gauge to the oil pressure sender oil galley port.
  3. Run the engine until normal operating temperature is reached.
  4. Run the engine at the specified RPM and record the gauge reading.
  5. The oil pressure should be within specifications; refer to GENERAL SPECIFICATIONS for 5.4L engines, GENERAL SPECIFICATIONS for 6.0L engines or GENERAL SPECIFICATIONS for 6.8L engines.
  6. If the pressure is not within specification, check the following possible sources:
    • Insufficient oil
    • Oil leakage
    • Worn or damaged oil pump
    • Oil pump screen cover and tube
    • Excessive main bearing clearance
    • Excessive connecting rod bearing clearance
scientia non olet · About LEMON Manuals