LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Engine Cooling System - F250-F550 Super Duty) >> Removal And Installation >> Bypass Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) for 5.4L 3V engines or ENGINE - 6.8L (3V) for 6.8L 3V engines.
  2. Remove the 3 bolts, the bypass tube, and discard the bypass tube gaskets.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
    • Inspect the mating surfaces and clean the sealing surfaces with metal surface prep and silicone gasket remover. Follow the directions on the packaging.
    • Install new bypass tube gaskets.
scientia non olet · About LEMON Manuals