LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1553 (Starting System - Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Starter Motor >> Removal

Starter Motor: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: When performing maintenance on the starting system, be aware heavy gauge leads are connected to the battery. Make sure protective caps are in place when maintenance is complete. Failure to follow these instructions may result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the starter solenoid protective cap.
    Fig 1: Locating Starter Solenoid Protective Cap
    G04649382Courtesy of FORD MOTOR CO.
  3. Label and disconnect the starter motor electrical connections.
    Fig 2: Locating Starter Mounting Bolts
    G04649383Courtesy of FORD MOTOR CO.
  4. Remove the 2 top starter mounting bolts.
  5. Remove the lower starter bolt and the starter.
scientia non olet · About LEMON Manuals