LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1544 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Front Slip Yoke >> Assembly

Driveshaft Universal Joint - Front Slip Yoke: Assembly

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Bearing cup installation 

    NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
  1. Install a new spider and bearing cup.
    1. Start a new bearing cup in the shaft yoke.
      • Check the needle bearings for correct positioning.
    2. Position the new spider in the shaft yoke.
    3. Press the bearing cup to just below the snap ring groove.
      Fig 1: Identifying Spider And Bearing Cup
      G04643326Courtesy of FORD MOTOR CO.
    2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap rings, install the black snap rings.
    Fig 2: Locating Snap Ring
    G03883359Courtesy of FORD MOTOR CO.
  2. Remove the shaft from the special tool, and install the new snap ring.

    3. Opposite bearing cup installation 

  3. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
    Fig 3: Installing Bearing Cup And Snap Ring On Opposite Side Of Shaft Yoke
    G04643328Courtesy of FORD MOTOR CO.
  4. Remove the shaft from the special tool, and install the new snap ring.
    5. CAUTION: Do not strike the bearings.
  5. Check the U-joint for freedom of movement.
    • If binding, strike the yoke with a brass or plastic hammer.
      Fig 4: Locating Strike Bearings
      G04643329Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals