LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1514 (Fuel Tank & Fuel Lines - (Except Hybrid)) >> Removal And Installation >> Fuel Tank Filler Pipe >> Installation

Fuel Tank Filler Pipe: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fuel tank filler pipe assembly in the vehicle.
    • Install the fuel tank filler pipe hose and clamp onto the fuel tank.
    • Tighten to 4 Nm (36 lb-in).
  2. Connect the fuel vapor vent hose to the EVAP canister.
  3. Attach the fuel vapor vent hose retainer clips.
  4. Connect the fuel vapor control tube assembly valve quick connect coupling onto the fuel tank filler tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  5. Install the fuel tank filler pipe mounting screw.
    • Tighten to 10 Nm (89 lb-in).
  6. Using the special tool, install the fuel tank tube shield with new rivets.
  7. Install the 2 fuel tank filler pipe mounting screws.
    • Tighten to 3 Nm (27 lb-in).
  8. Install the fuel tank filler cap.
  9. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  10. Turn the ignition key to the ON position to pressurize the fuel system.
  11. Visually inspect the fuel system for leaks.
scientia non olet · About LEMON Manuals