LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Exterior Trim And Ornamentation) >> Removal And Installation >> Rocker Panel Moulding - Mariner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front rocker panel moulding screw.
  2. Remove the 2 rear rocker panel moulding screws.
  3. Remove the 6 rocker panel moulding pin-type retainers.
  4. Remove the rocker panel moulding.
    NOTE: When removing the rocker panel moulding use a wedge type tool to assist in the removal, start at one end and proceed to the opposite end.
  5. To install, reverse the removal procedure.
    NOTE: The rocker panel moulding retainer clips are one-time use only. New clips must be used during installation.
scientia non olet · About LEMON Manuals