LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Exterior Trim And Ornamentation) >> Removal And Installation >> Fender Moulding >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the fender moulding pin-type retainer.
    Fig 1: Removing Fender Moulding Pin-Type Retainers
    G04622228Courtesy of FORD MOTOR CO.
  3. Remove the fender moulding.
    NOTE: Release the moulding retaining clips from inside the fender.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals