LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1473 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Pads - Hybrid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not allow brake fluid to overflow from the master cylinder reservoir. Brake fluid may damage the high-voltage components.
NOTE: The rear brake pads will wear at approximately twice the rate of the front brake pads.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  2. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
    • Remove the battery junction box (BJB) fuses 24 (50A) and 31 (50A).
  3. Remove the 2 brake caliper guide bolts.
    • To install, tighten to 35 Nm (26 lb-ft).
    4. CAUTION: Do not allow the brake caliper to hang by the brake caliper jounce hose.
  4. Remove the brake caliper and secure the brake caliper to the vehicle.
  5. Remove the inboard and outboard brake pads from the brake caliper.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals