LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1461 (Acceleration Control System - (Except Hybrid)) >> Removal And Installation >> Accelerator Pedal and Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accelerator cable from the rubber plunger.
    Fig 1: Removing Accelerator Cable From Rubber Plunger
    G04621284Courtesy of FORD MOTOR CO.
  2. Position the plunger rearward and remove the cable from the accelerator pedal.
    Fig 2: Removing Cable From Accelerator Pedal
    G04621285Courtesy of FORD MOTOR CO.
  3. Remove the 2 bolts and the accelerator pedal and shaft assembly.
    • To install, tighten to 9 Nm (80 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals