LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1454 (Exhaust System) >> Removal And Installation >> Catalytic Converter - 3.0L RH Exhaust Manifold >> Removal

Catalytic Converter - 3.0L RH Exhaust Manifold: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the exhaust Y-pipe. For additional information, refer to EXHAUST Y-PIPE - 3.0L .
  2. Disconnect the RH heated oxygen sensor (HO2S) electrical connector.
  3. Disconnect the (EGR) tube nut from the RH catalytic converter.
  4. Remove and discard the 6 RH catalytic converter manifold nuts and remove the converter.
    • Discard the RH catalytic converter manifold gasket.
  5. Remove and discard the 6 RH catalytic converter studs.
  6. Clean and inspect the RH catalytic converter manifold.
scientia non olet · About LEMON Manuals