LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Repair >> Valve Cover >> Installation

Valve Cover: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths.
  1. Clean and inspect the sealing surfaces.
    2. NOTE: Clean and inspect the gasket. Install a new gasket, if necessary.
  2. Install the valve cover, gasket and retainers.
    • Tighten in the sequence shown to 10 N.m (89 lb-in).
      Fig 1: Identifying Valve Cover Bolts
      G04617886Courtesy of FORD MOTOR CO.
  3. Position the wiring harness and attach all of the wiring harness retainers to the valve cover studs.
  4. Position the power steering tube and bracket.
    • Tighten to 6 N.m (53 lb-in).
  5. Position the accelerator control cable and brackets.
    • Tighten to 6 N.m (53 lb-in).
  6. Attach the vacuum tube and the pin-type retainer to the intake manifold.
  7. Connect the CHT sensor electrical connector.
  8. Connect the fuel rail pressure and temperature sensor electrical connector.
  9. Connect the CMP sensor electrical connector.
  10. Install the coolant vent tube, brackets and nuts.
    • Tighten to 6 N.m (53 lb-in).
  11. Connect the crankcase vent hose.
  12. Install the ignition coil-on-plugs. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals