LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Safety Belt System) >> Removal And Installation >> Safety Belt Shoulder Height Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS], if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of personal injury in collisions.
  1. Remove the upper B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the 2 bolts and safety belt shoulder height adjuster.
    • To install, tighten to 40 Nm (30 lb-ft).
    3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
  3. To install, reverse the removal procedure.
  4. Check the active restraints for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals