Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
- Remove the exterior front door handle. For additional information, refer to EXTERIOR FRONT DOOR HANDLE.
- Disconnect door lock cylinder actuating rod.
- If equipped, disconnect the door disarm switch electrical connector.
- Remove the clip and the door lock cylinder.
- To install, reverse the removal procedure.