LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Drive Shafts) >> Removal & Installation >> Front Drive Shaft >> Removal

Front Drive Shaft: Removal

WARNING: This page is about a different car, the 2002 Mercury Mountaineer, 2002 Ford Ranger, 2002 Ford Explorer Sport Trac, 2002 Ford Explorer Sport, and 2002 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in Neutral, raise and support the vehicle. Index mark the front axle pinion flange and the front drive shaft. See Fig 1 . Index mark the front output shaft assembly and the front drive shaft Constant Velocity (CV) joint. See Fig 2 .
  2. Remove and discard the bolts and washers. Remove and discard the bolts and universal joint retainers. The front drive shaft CV joint is not repairable. Remove the drive shaft. See Fig 3 .
Fig 1: View Of Index Mark At Front Differential
G00196594Courtesy of FORD MOTOR CO.
Fig 2: View Of Index Mark At Transfer Case
G00196595Courtesy of FORD MOTOR CO.
Fig 3: Removing Drive Shaft
G00196596Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals