Clear The Continuous Diagnostic Trouble Codes (DTCS) And Reset The Emission Monitors Information In The Powertrain Control Module (Pcm): Description
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Milan, and 2006 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Clear the continuous diagnostic trouble codes (DTCs) and reset the emission monitors information in the powertrain control module (PCM) was previously called PCM reset.
All on board diagnostics (OBD) diagnostic tools support the clearing of continuous DTCs and resetting of emission monitors information in the PCM.
The clearing of the continuous DTCs allows the diagnostic tool to command the PCM to clear/reset all emission-related diagnostic information. While carrying out this operation a DTC P1000 is stored in the PCM until all the OBD system monitors or components have been tested to satisfy a drive cycle without any other concerns occurring. For more information about a drive cycle, refer to ON BOARD DIAGNOSTIC (OBD) DRIVE CYCLE .
The following events occur when the continuous DTCs and emission monitors information is cleared from the PCM:
- clears the number of DTCs
- clears the DTCs
- clears the freeze frame data
- clears the diagnostic monitoring test results
- resets the status of the OBD system monitors
- sets DTC P1000