LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1317 (Bumpers) >> Removal And Installation >> Rear Bumper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper cover. For additional information, refer to REAR BUMPER COVER  in this article.
  2. Remove the 2 rivets and the rear bumper cover isolator.
    • Use the special tool to install the new rivets.
  3. Remove the bolt and the exhaust bracket.
    • To install, tighten to 30 Nm (22 lb-ft).
  4. Remove the 4 bolts and the rear bumper.
    • To install, tighten to 23 Nm (17 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals