Front Door Window Glass: Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front door window glass against the B-pillar.
- Support the front door window glass and raise the front door window regulator to the full upright position.
- Tighten the 2 front door window regulator-to-glass clamp bolts after the glass is fully seated in the clamp.
- Tighten to 12 Nm (9 lb-ft).
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the window control switch electrical connector.
- Install the interior weatherstrip.
- Install the watershield.
- Install the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
NOTE:
Make sure the front door window glass correctly seats in the glass mounting brackets as the front door window regulator is raised.