LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Exterior Lighting) >> Removal And Installation >> High Mounted Stoplamp >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat bolsters. For additional information, refer to SEATING .
  2. Position the rear quarter trim panels aside.
  3. Remove the rear passenger assist handles.
    CAUTION: Do Not excessively lower the rear portion of the headliner. This can create creases or kinks in the headliner.
  4. Position the headliner aside.
  5. Disconnect the electrical connector.
  6. Remove both the high-mounted stoplamp screws.
    • To install, tighten to 5 Nm (44 lb-in).
  7. Remove the high-mounted stoplamp.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals