Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Drain the fuel tank. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
Remove the driveshaft. For additional information, refer to DRIVESHAFT .
Remove the 2 pin-type retainers and the bolt and position aside the fuel tube shield.
- To install, tighten to 5 Nm (44 lb-in).
Fig 1: Removing Fuel Tube Shield Pin-Type Retainers And Bolt
Courtesy of FORD MOTOR CO.
Disconnect the vapor tube and the fuel supply tube quick connect coupling. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
Disconnect the fuel filler pipe hose from the fuel tank.
Position a suitable lifting device to support the fuel tank.

Fig 2: Positioning Lifting Device Under Fuel Tank
Courtesy of FORD MOTOR CO.
Remove the 2 fuel tank strap mounting bolts and position aside the 2 fuel tank straps.
- To install, tighten to 35 Nm (26 lb-ft).
Disconnect the fuel tank electrical connector.
Partially lower the fuel tank and disconnect the vapor tube quick connect coupling. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .

Fig 3: Locating Vapor Tube Quick Connect Coupling
Courtesy of FORD MOTOR CO.
Remove the fuel tank.
To install, reverse the removal procedure.
- Turn the ignition key to the ON position to pressurize the fuel system.
- Visually inspect the fuel system for leaks.