LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1272 (Electronic Engine Controls) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    Both camshaft position (CMP) sensors 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Remove the throttle body. For additional information, refer to FUEL CHARGING & CONTROLS - 3.0L (4V) .

    4. RH CMP sensor 

  4. Remove the 2 bolts, the nut and the upper intake manifold support bracket.
    • To install, tighten to 10 Nm (89 lb-in).
  5. Disconnect the RH CMP electrical connector.
  6. Remove the bolt and the RH CMP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect and install a new O-ring seal as necessary.

    7. LH CMP sensor 

  7. Remove the fuel tube bracket bolt and position the fuel tube aside.
    • To install, tighten to 10 Nm (89 lb-in).
  8. Disconnect the LH CMP sensor electrical connector.
  9. Remove the bolt and the LH CMP sensor.
    • To install, tighten to 6 Nm (53 lb-in).
    • Inspect and install a new O-ring seal as necessary.

    10. Both CMP sensors 

    NOTE: Lubricate the O-ring seals with clean engine oil.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals