LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the RH ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION - 3.0L (4V) .
  3. Disconnect the crankcase vent tube from the valve cover.
  4. Disconnect the variable cam timing (VCT) solenoid electrical connector.
  5. Detach the wiring retainer from the valve cover stud bolt.
  6. Remove the 2 intake manifold support bracket nuts and position the support bracket aside.
  7. Remove the 4 nuts and position the wiring harness conduit aside.
  8. Remove the 12 stud bolts and the valve cover.
scientia non olet · About LEMON Manuals