Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the front cover and the crankshaft front seal inner lip with clean engine oil.

NOTE: Sealing surface must be free of dirt and oil.

Fig 1: Identifying Silicone Sealant Application Area At End Of Keyway Slot

Courtesy of FORD MOTOR CO.

Apply silicone gasket and sealant to the end of the keyway slot.

NOTE: Lubricate the outside diameter sealing surface of the crankshaft pulley with clean engine oil.

Fig 2: Installing Crankshaft Pulley

Courtesy of FORD MOTOR CO.

Using the special tool, install the crankshaft pulley.
Using the special tool to hold the crankshaft pulley, install a new bolt. Tighten the bolt in 4 stages:
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn (360 degrees).
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.
Fig 3: Holding Crankshaft Pulley Using Special Tool
Courtesy of FORD MOTOR CO.
Install the front center splash shield.
Install the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .