LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1253 (Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The electronic parking brake (EPB) system must be reset following the EPB system reset procedure if the battery has been disconnected. Refer to ELECTRONIC PARKING BRAKE (EPB) RESETTING  in the diagnostic article .
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Release the floor console finish panel cup holder from the floor console finish panel and position it aside.
  3. Disconnect the parking brake switch electrical connector from the parking brake switch.
  4. Remove the 4 parking brake switch screws.
  5. Release the parking brake switch from the floor console finish panel cup holder.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals