LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1252 (Rear Disc Brakes) >> Removal And Installation >> Rear Brake Pads >> Installation

Rear Brake Pads: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, compress the brake caliper piston into the disc brake caliper.
    Fig 1: Compressing Brake Caliper Piston Into Disc Brake Caliper
    G03983437Courtesy of FORD MOTOR CO.
  2. Position the notch in the caliper piston up and down to align with the alignment pin on the brake pad.
  3. Install the new spring clips and brake pads.
  4. Position the brake caliper and install the 2 bolts.
    • Tighten to 35 Nm (26 lb-ft).
scientia non olet · About LEMON Manuals