LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1252 (Rear Disc Brakes) >> Removal And Installation >> Rear Brake Caliper Support Bracket >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the brake pads. For additional information, refer to BRAKE PADS  in this article .
  3. Remove the 2 bolts and the brake caliper anchor plate.
    • Tighten to 103 Nm (76 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals