LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1249 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Pilot Bearing and Seal >> Removal

Stub Shaft Pilot Bearing and Seal: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the halfshaft assembly. For additional information, refer to .
  2. Using the special tools, remove the inboard CV joint stub shaft pilot bearing housing seal.
    Fig 1: Removing Inboard CV Joint Stub Shaft Pilot Bearing Housing Seal
    G03995195Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals