LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1249 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Pilot Bearing and Seal >> Installation

Stub Shaft Pilot Bearing and Seal: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the lip of the inboard CV joint stub shaft pilot bearing housing seal with grease. Place the inboard CV joint stub shaft pilot bearing housing seal onto the special tools.
    Fig 1: Placing Inboard CV Joint Stub Shaft Pilot Bearing Housing Seal Onto Special Tools
    G03995196Courtesy of FORD MOTOR CO.
    2. CAUTION: Installation of the inboard CV joint stub shaft pilot bearing housing seal without the correct tool can result in early inboard CV joint stub shaft pilot bearing housing seal failure. If the inboard CV joint stub shaft pilot bearing housing seal becomes cocked during installation, remove it and install a new one.
  2. Carefully align the inboard CV joint stub shaft pilot bearing housing seal with the housing bore, then install the inboard CV joint stub shaft pilot bearing housing seal.
  3. Install the halfshaft assembly. For additional information, refer to .
scientia non olet · About LEMON Manuals