Removal and Installation

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle front axle. .
Remove the nut at the rear of the track bar bracket.

Fig 1: Removing Nut From Rear Of Track Bar Bracket
Courtesy of FORD MOTOR CO.

NOTE: The bolt has two flats on the shank which must be aligned with the bracket when installed.

Remove the left track bar bolt.
Remove the right track bar bolt. The bolt threads directly into the front axle.

Fig 2: Removing Right Track Bar Bolt
Courtesy of FORD MOTOR CO.
Remove the track bar.
To install, reverse the removal procedure.