Variable Cam Timing Unit Assembly
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2003 Mercury Sable, 2003 Mercury Mountaineer, 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Variable Cam Timing (VCT) unit assembly is coupled to camshaft through a helical spline in the VCT unit chamber. See Fig 1. When flow of oil is shifted from one side of the chamber to the other, differential change in oil pressure forces piston to move linearly along the axis of the camshaft. This linear motion is translated into rotational camshaft motion through the helical spline coupling. A spring installed in the chamber is designed to hold camshaft in minimum overlap position (5 degrees) when oil pressure is too low to maintain adequate position control. Camshaft is allowed to rotate up to 30 degrees.