Safety Belt Shoulder Height Adjuster - Front Row
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART
| Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) |
WARNING:
All safety belt assemblies including retractors, buckles, belt tension sensor (BTS), if equipped, front seat belt buckle support assemblies (slide bar), if equipped, shoulder belt height adjusters, if equipped, child safety seat tether bracket assemblies, if equipped, and attaching hardware should be inspected after any collision. Ford recommends new safety belt assemblies be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Safety belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.
The Automatic Locking Retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a child seat is functioning properly, in addition to other checks for proper safety belt system function. A belt and retractor assembly must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating properly when inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.
The Automatic Locking Retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a child seat is functioning properly, in addition to other checks for proper safety belt system function. A belt and retractor assembly must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating properly when inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.
- Remove the front and rear door opening weatherstrips along the upper portion of the B-pillar trim panel.
- Remove the D-ring bolt.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the upper B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION
.
- To install, raise the safety belt height adjuster and trim panel slider plate to the uppermost position for correct installation.
- Remove the safety belt shoulder height adjuster bolt.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the safety belt shoulder height adjuster.
- Rotate the safety belt shoulder height adjuster downward to release the lower tab.
- Remove the safety belt shoulder height adjuster.
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .