LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1226 (Seat System) >> Removal And Installation >> Rear Seat - 40 Percent E-Z Entry, Second Row >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LH seat shown, RH seat similar.
  1. Remove the 2 front rubber nut caps.
  2. Remove the 2 front riser-to-floor nuts.
  3. Fold the affected 40 percent seat up to the E-Z entry position.
  4. Remove the 3 rear seat riser-to-floor bolts.
  5. Remove the 40 percent seat.
  6. To install, reverse the removal procedure.
  7. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals