LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1216 (Auxiliary Climate Control) >> Removal And Installation >> Auxiliary Heater Outlet and Inlet Line - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Drain the engine coolant. For additional information, refer to ENGINE COOLING .
  3. Remove the RH running board brackets.
  4. Remove the 4 heater hose front and rear clamps.
  5. Remove the auxiliary line front bracket.
  6. Remove the auxiliary line rear bracket nut.
  7. Remove the auxiliary line rear bracket.
  8. Remove the 3 auxiliary line center bracket bolts.
  9. Remove the 3 auxiliary line center brackets.
  10. Remove the auxiliary heater outlet line.
  11. Remove the auxiliary heater inlet line.
  12. To install, reverse the removal procedure.
    • Lubricate the coolant hoses with plain water only, if needed.
  13. Fill the engine coolant level. For additional information, refer to ENGINE COOLING .
scientia non olet · About LEMON Manuals