LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1174 (Acceleration Control System) >> Removal And Installation >> Accelerator Pedal - Fixed >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the accelerator pedal electrical connector.
  3. Remove the nuts and the accelerator pedal assembly.
    • To install, tighten to 7 Nm (62 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals