LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine -- 4.6L (2V)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH exhaust manifold. For additional information, refer to EXHAUST MANIFOLD - LH .
  2. Remove the bolt and the oil level indicator and tube.
    • To install, tighten to 10 Nm (89 lb-in).
  3. Remove and discard the oil level indicator tube O-ring seal.
    4. NOTE: Install a new oil level indicator tube O-ring seal and lubricate it with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals