LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1153 (Engine -- 4.0L SOHC) >> In-Vehicle Repair >> Camshaft Roller Follower >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH and RH valve covers. For additional information, refer to VALVE COVER - RH  and VALVE COVER - LH .
  2. Remove the fuel rail. For additional information, refer to FUEL CHARGING AND CONTROLS - 4.0L SOHC .
  3. Remove the cooling fan. For additional information, refer to ENGINE COOLING .
  4. Rotate the crankshaft until the camshaft for the cylinder being serviced is at base circle.
    Fig 1: Identifying Base Circle Position
    G03947421Courtesy of FORD MOTOR CO.
    5. NOTE: Mark each camshaft roller follower to make sure it is returned to its original position.
    Fig 2: Removing Camshaft Roller Using Special Tool
    G03947065Courtesy of FORD MOTOR CO.
  5. Using the special tool, remove the camshaft roller followers.
    6. NOTE: The camshaft roller followers must be installed in their original positions.
    NOTE: Lubricate the camshaft roller followers with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals