LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1149 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake Shield >> Installation

Rear Disc Brake Shield: Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If installing a new brake disc shield, cut the new shield in two at the perforations.
  1. Position the brake disc shield halves, and install the 2 bolts (part number W505321-S426) in each half.
    • Tighten to 12 Nm (9 lb-ft).
  2. Install the parking brake shoes. For additional information, refer to PARKING BRAKE AND ACTUATION .
scientia non olet · About LEMON Manuals