Canister Vent Solenoid Closing Procedure
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART
| Worldwide Diagnostic System (WDS) Vehicle Communication Module (VCM) with appropriate adapters, or equivalent diagnostic tool |
CAUTION:
The canister vent solenoid must not be energized for more than 9 minutes at one time. Once the canister vent solenoid is energized and de-energized, adequate time must be allowed for the component to cool adequately. Failure to allow the component to cool may create a false failure in the diagnostics, causing unnecessary repairs.
- Connect the diagnostic tool and select the output test mode.
- If parameter identification (PID) monitors are not active, select PIDs.
- Select the fuel tank pressure (FTP) and the volts (V) PID for monitoring.
- Select the ALL OFF mode.
- Close the canister vent solenoid by pushing the START button on the diagnostic tool.