Pinpoint Test F: Anti-Theft Number Of Programmed Keys Is Below Minimum: Testing

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

F1 RETRIEVE THE DIAGNOSTIC TROUBLE CODES (DTCS)
- Key in OFF position.
- Enter the following diagnostic mode on the diagnostic tool: Retrieve the DTCs.
- Enter the following diagnostic mode on the diagnostic tool: Clear the DTCs.
- Key in ON position.
- Enter the following diagnostic mode on the diagnostic tool: Retrieve the DTCs.
- Is DTC B1213 retrieved?
- Yes : GO to F2.
- No : If other than PATS PCM DTCs are retrieved, REFER to the INTRODUCTION - GASOLINE article .
  If no PATS DTCs are retrieved, the system is OK.
F2 MONITOR THE PCM PID NUMKEYS
- Enter the following diagnostic mode on the diagnostic tool: Monitor PIDs.
  Monitor the PCM PID NUMKEYS.
- Does the PCM PID NUMKEYS display less than 2 PATS keys programmed?
- Yes : GO to F3.
- No : The system is OK.
F3 PROGRAM THE PATS KEYS
- Cut a new PATS key.
- Program the new PATS key. Refer to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
- Does the anti-theft indicator illuminate for 3 seconds and then go out?
- Yes : CLEAR the DTCs. CYCLE the ignition switch OFF then back to RUN to verify all codes have been cleared. CLEAR the DTCs. REPEAT the self-test.
- No : GO to F4.
F4 CHECK FOR SERV_MOD PID - MONITOR THE PCM PID SERV_MOD
- Enter the following diagnostic mode on the diagnostic tool: Retrieve the DTCs.
- Monitor the PCM PID SERV_MOD.
- Does the PCM PID SERV_MOD indicate YES?
- Yes : PROGRAM the PATS keys. REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT . CLEAR the DTCs. REPEAT the self-test.
- No : If the anti-theft indicator is illuminated continuously, REPEAT Step F3 using a new PATS key. If the anti-theft indicator is flashing, RETRIEVE the PCM DTC stored for the new PATS fault. REFER to the PASSIVE ANTI-THEFT SYSTEM (PATS) - DIAGNOSTIC TROUBLE CODES (DTC) INDEX .