LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1121 (Anti-Theft System -- Pats) >> Diagnosis And Testing >> Passive Anti-Theft System (PATS) - Inspection and Verification >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Large metallic objects or electronic devices on the key chain that can be used to purchase gasoline or similar items
    • Ignition lock cylinder
    • PATS key
    • Use of a non-PATS key
    • More than one PATS key on the key chain
    • Smart junction box (SJB) fuse 18 (10A)
    • PATS transceiver module
    • Powertrain control module (PCM)
    • Ignition switch
    • Loose or corroded connection(s)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • CAN circuits fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for the PCM, refer to MODULE COMMUNICATIONS NETWORK .
    • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out self-test diagnostics for the PCM.
  7. If the DTCs retrieved are related to the concern, go to the PASSIVE ANTI-THEFT SYSTEM (PATS) - DIAGNOSTIC TROUBLE CODES (DTC) INDEX  to continue diagnosis.
  8. If no DTCs related to the concern are retrieved, refer to PASSIVE ANTI-THEFT SYSTEM (PATS) - SYMPTOM CHART .
scientia non olet · About LEMON Manuals