Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the C-pillar trim screw cover.
- Remove the C-pillar trim screw.
- Remove the 2nd row safety belt anchor-to-floor bolt.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the C-pillar trim panel.
- Pull the C-pillar trim panel toward the inside of the vehicle to release the retaining clips.
- To install, reverse the removal procedure.