LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Seat System) >> Removal And Installation >> Seat Recliner - Second Row, 40 Percent, Freestyle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the backrest folded down, release the backrest trim cover lower J-clip.
  2. Release the 2 backrest trim cover inside J-clips to hard back panel.
  3. Roll the backrest trim cover up to access the 2 recliner-to-backrest frame bolts.
  4. Pull the cushion trim cover outboard retainer out from between the riser/seat track and the cushion frame.
    Fig 1: Pull Cushion Trim Cover Outboard Retainer Out From Between Riser/Seat Track And Cushion Frame
    G03988932Courtesy of FORD MOTOR CO.
  5. Remove 2 screws, pull and remove the riser/seat track LH inner cover.
  6. Remove 3 screws and the riser/seat track LH outer cover.
  7. Remove the screw and the recliner handle.
  8. Remove 2 screws, pull and remove the recliner outer cover.
    • On assembly, make sure the release strap is through the cover opening.
  9. Remove the pin-type retainer, release the locator tabs and remove the recliner inner cover.
    10. NOTE: Note cable routing for installation.
  10. Remove the 2 cables from the recliner.
    11. CAUTION: The recliner is spring loaded. If the lever is released, the spring load on the recliner will be released, pivoting the recliner arm very quickly to the release position. Use care when releasing the lever and stay away from the pivoting recliner arm.
  11. Remove the 4 bolts and the recliner.
    • To install, tighten to 50 Nm (37 lb-ft).
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals