LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Seat System) >> Removal And Installation >> Seat Recliner - Inboard, Second Row, 60 Percent, Freestyle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 60 percent seat from the vehicle. For additional information, refer to SEAT - REAR, SECOND ROW, FREESTYLE .
  2. Remove the 60 percent rear seat backrest. For additional information, refer to SEAT BACKREST - SECOND ROW, 60 PERCENT, FREESTYLE .
  3. Remove the pin-type retainer, screw and the RH recliner cover.
  4. Remove the 3 RH recliner-to-riser bolts.
    • To install, tighten to 50 Nm (37 lb-ft).
    5. NOTE: Note cable routing for installation.
  5. Remove the cushion frame yoke-to-RH recliner bolt, detach the cable and remove the RH recliner.
    • To install, tighten to 50 Nm (37 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals