LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Fuel Tank & Fuel Lines) >> Removal And Installation >> Inertia Fuel Shutoff (IFS) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to JACKING & LIFTING .
  2. Remove the RH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Disconnect the inertia fuel shutoff (IFS) switch electrical connector.
  4. Remove the 2 IFS switch retaining bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
  5. Remove the IFS switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals