LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Latch >> Installation

Front Door Latch: Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, position the door disarm switch and the door lock cylinder pawl on the door lock cylinder and install the circlip.
  2. Install the front door latch on the bracket.
  3. Connect the interior door handle cable to the latch.
    Fig 1: Connecting Interior Door Handle Cable To Latch
    G03989253Courtesy of FORD MOTOR CO.
  4. Install the remote cable cover on the latch.
    Fig 2: Installing Remote Cable Cover On Latch
    G03989255Courtesy of FORD MOTOR CO.
  5. Connect the push button rod to the front door latch.
  6. Connect the door ajar switch and the door lock actuator electrical connectors.
  7. Position the door module and install the 11 bolts.
    • Tighten to 8 Nm (71 lb-in).
  8. Install the 3 front door latch bolts.
    • Tighten to 12 Nm (9 lb-ft).
    9. CAUTION: The exterior door handle and the door latch must be installed and tightened to specification before connecting the exterior door handle actuating rod with the yellow clip.
    CAUTION: The exterior door handle actuating rod must be hanging freely then clipped into the door latch. Loading the exterior door handle actuating rod up or down when connecting may result in a misadjustment of the latch causing the latch not to operate correctly.
  9. Connect the exterior door handle actuating rod to the front door latch and close the yellow clip.
  10. If equipped, connect the front door lock cylinder actuating rod to the front door lock cylinder pawl.
  11. Tighten the 2 window glass clamp bolts.
    • Position the window in both the window clamps.
    • Shift the door window glass fully rearward.
    • Tighten the 2 window glass bolts to 8 Nm (71 lb-in).
  12. Push the wiring harness grommet through the door module.
  13. If equipped, connect the remote keyless entry (RKE) keypad and front door disarm switch electrical connectors.
  14. If equipped, connect the exterior mirror electrical connector.
  15. Install the water shield.
  16. Position the interior door handle and loosely install the bolt.
  17. Install the front door interior trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  18. Center the inside door handle alignment pins to the front door trim panel and tighten the interior door handle.
    • Tighten to 7 Nm (62 lb-in).
scientia non olet · About LEMON Manuals