LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Air Bag Restraint Systems) >> Removal & Installation >> Driver-Side Air Bag Module >> Removal

Driver-Side Air Bag Module: Removal

WARNING: This page is about a different car, the 2002 Lincoln Navigator and 2002 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Driver-side air bag module is located in center of steering wheel. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove 2 back cover plugs on back side of steering wheel. Remove driver-side air bag module mounting bolts. Pull air bag module away from steering wheel. Disconnect horn and clockspring electrical connectors from air bag module. Remove air bag module from steering wheel.
  3. Remove air bag simulator from clockspring harness connector. Connect Air Bag Simulator (418-F088/105-R0012) to harness side of upper clockspring connector, at top of steering column. Connect negative battery cable. With air bag simulators installed at all deployable air bag system devices, perform system operation check. See SYSTEM OPERATION CHECK  . Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
scientia non olet · About LEMON Manuals