LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Air Bag Restraint Systems) >> Diagnostic Tests >> Test AJ: Left PRETENSIONER Circuit Short To Ground (DTC B1879) >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2002 Lincoln Navigator and 2002 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

A short to ground in left seat belt pretensioner circuit could be caused by short to ground in Light Green/Red wire (circuit No. 1079), short to ground in Light Green/Black wire (circuit No. 1080), short to ground in left seat belt pretensioner, or RCM internal fault.

  1. Check for hard or intermittent DTCs

    Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). See USING SCAN TOOL  under DIAGNOSTICS. Turn ignition switch to RUN position. Retrieve and record any continuous DTCs. See RETRIEVING FAULT CODES  . Clear continuous DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS. Perform on-demand self-test. See ON-DEMAND SELF-TEST  under DIAGNOSTICS. If DTC B1879 was retrieved during on-demand self-test, fault is hard. Go to next step. If DTC B1879 was not retrieved, fault is intermittent. Go to step  4 .

  2. Check left seat belt pretensioner

    Turn ignition switch to OFF position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Turn ignition switch to RUN position. Perform on-demand self-test. If DTC B1879 was retrieved during on-demand self-test, go to next step. If DTC B1879 was not retrieved during on-demand self-test, replace left seat belt pretensioner. See SEAT BELT PRETENSIONER  under REMOVAL & INSTALLATION. Go to step  5 .

  3. Check left seat belt pretensioner circuits

    Turn ignition switch to OFF position. Access RCM and disconnect harness connector C2005. See RESTRAINTS CONTROL MODULE (RCM)  under REMOVAL & INSTALLATION. Disconnect left seat belt pretensioner simulator from harness connector. Measure resistance between ground and harness side of RCM connector C2005, terminal No. 18 (Light Green/Red wire). See Figure . Measure resistance between ground and harness side of RCM connector C2005, terminal No. 22 (Light Green/Black wire). If resistance is less than 10 k/ohms in either circuit, repair short to ground in appropriate wire. See WIRING DIAGRAMS  . Go to step  5 . If resistance is more than 10 k/ohms in both circuits, replace RCM. Go to step  5 .

  4. Check for intermittent fault

    Refer to continuous DTCs recorded in step  1 . If DTC retrieved in step  1 was an intermittent fault, check for cause of intermittent short to ground in Light Green/Red or Light Green/Black wire. See WIRING DIAGRAMS  . Attempt to recreate fault by flexing wire harness and cycling ignition switch frequently. Repair any intermittent problems found. Go to next step. If DTC retrieved in step  1 was not an intermittent fault, go to next step.

  5. Check for additional DTCs

    Refer to continuous DTCs recorded in step  1 . If any continuous DTCs were retrieved, go to diagnostic trouble code identification table for direction to appropriate test. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION  table. DO NOT clear any DTCs until all DTCs have been resolved. If no DTCs were retrieved, reconnect air bag system. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Clear all DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS.
scientia non olet · About LEMON Manuals