LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Fuel System >> Fuel Rails & Injectors >> Removal & Installation (4.6L)

Removal & Installation (4.6L)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable. Partially drain cooling system. Remove power steering reservoir bracket. Remove accelerator cable splash shield. Disconnect vacuum hose from fuel pressure regulator.
  2. Disconnect fuel supply and return line connections at fuel supply manifold. Disconnect coolant inlet hose. Disconnect fuel injector and ignition coil wiring harness connectors. Remove coolant hose. Remove brake booster bracket and tube. Remove PCV hose.
  3. Remove EGR valve-to-exhaust manifold tube. Disconnect EGR valve and EGR transducer hoses. Disconnect Vapor Management Valve (VMV) hose. Remove fuel rail bolts. Remove fuel rail with injectors. Remove injectors by using a rocking motion. See Figure. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals