Removal & Installation (Except Explorer & Mountaineer)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Remove fuel tank. See FUEL SYSTEM PRESSURE RELEASE . Remove screws or lock ring and fuel pump tank unit. Wipe seal area of tank clean. Position NEW seal onto pump mounting flange (if necessary), using grease to hold it in position. Position fuel pump in tank to original position. Install bolts or lock ring. DO NOT overtighten lock ring, as it may leak. Install fuel tank. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .