LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Supplemental Inflatable Restraint System -- Excursion & F250-550 Super Duty) >> Removal & Installation >> Driver-Side Air Bag Module >> Removal

Driver-Side Air Bag Module: Removal

WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, 2002 Ford Excursion, and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove 2 back cover plugs from rear of steering wheel. Remove 2 driver-side air bag module mounting bolts. Disconnect horn switch and air bag electrical connectors. Remove air bag module from vehicle.
  3. Remove air bag simulator from clockspring harness connector. Connect Air Bag Simulator (418-F088/105-R0012) to harness side of clockspring connector at top of steering column. Connect negative battery cable. With air bag simulators installed at all deployable devices, perform system operation check. See SYSTEM OPERATION CHECK . Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
scientia non olet · About LEMON Manuals