LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1079 (Engine System-General Information) >> General Procedures >> Camshaft End Play - OHC Engines >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION

G03878636
 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent
  1. Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the indicator.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install new camshaft and recheck end play. Refer to the appropriate engine article for the procedure.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head. Refer to the appropriate engine for the procedure.
      Fig 1: Using Dial Indicator Gauge With Holding Fixture To Measure Camshaft End Play
      G03885002Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals